Skip to main content

Civil engineering Interview questions at L&T

  • Hacking on column :- 50 nos in 1sqfeet or 500 nos in 1sqmeter


  • Cover blocks center to center distance :- 600 mm to 1 meter
  • Beam shall not have width less than 200mm
  • For 750mm depth beam provide :- Side Face Reinforcement & also called STIFFNOR
  • Width to depth ratio of beam should be more then 0.3
  • Yoke interval in column should be 600 m / 2feet
  • Diameter of needle for compaction in column = 40mm





Why steel always circular ?
      Because circular patterns stress distribution equally.



What slope you will provide if you are constructing staircase according IS 456 ?
  Answer :- 25° to 40°


What's the least count of theodolite of compass ?

Theodolite least count is 20 second
Compass least count is 30 minute

Labels:

Comments

Post a Comment

Popular posts from this blog

Basic civil engineering interview questions

Basic civil engineering interview questions Minimum spacing between chairs is 1 metre sand used in India obtained from Ennore ( Tamil Nadu) Concrete cube is filled in 3 layers Minimum percentage of steel in column is 0.8 % of gross area 1 yard is equal to 3 feet Slump cone field in 4 layers Binding wire required of 1 metric ton is 8 kg to 10 kg Technical name of binding wire is Annealed wire What is ties ? Ties are transverse reinforcement of column What is stirrups ? Stirrups is transverse reinforcement of beam What are the concrete test ? Slump test Compressive strength test Water permeability test Water absorption test Type of slumps True slumps -   the concrete mass after the test when slumps evenly all around without disintegration is called TRUE slump . Shear slump - when one half of the concrete mass slide down the other is called   Shear slump. This type of slope obtained in a lean concrete mix Collapse slump - when the sample is collapse due to addin...
Post a Comment
Read more

Important point of a civil engineer interview

 What is segregation ? Separation of cement sand from aggregate in the concrete. water cement ratio is not proper or As per  IS code height  more than 1.5 meters also segregation. What is bleeding ? Water comes out to the surface of concrete is called bleeding.  It also a type of segregation.   Function of stirrups ? To regist shear force and positioning the main reinforcement. What is the function of foundation? To increase the suitability of structure. What is the 3 4 5 method ?  It is used to set up the plane at right angle. Full form of DPC ?  Damp proof course Minimum die of bored cast insitu pile ? As per IS 2911 part 1 section 2  =  450 mm. Factor used to convert weight to dry volume of concrete ?    Is 1.54   Example :-   if a column wet volume is 3 cum than the dry volume = 3* 1.54= 4.62 cum
3 comments
Read more